聯系我們
18560023440
王經理：18560023440
地址：山東省德州市齊河縣經濟開發區齊眾大道7號-2車間
業內資訊
保麗龍泡沫雕刻機具體配置什么樣的驅動器合適 ？
來源：http://www.tj9.net 時間：2021-03-31
在選取泡沫雕刻機時，有一些客戶對功率產生疑問，客戶會問我做什么什么的，這樣的要選擇多大功率的設備呢，保麗龍泡沫雕刻機，對于這個問題，山東墨源數控進行以下講解：
When choosing foam engraving machine, some customers are wondering about power. Customers will ask me what to do and what to choose. How to choose high-power equipment, and the foam Dragon carving machine?
隨著人們對數控泡沫雕刻機率、高性能的加工效率認知，越來越多的客戶在選購和引進數控泡沫雕刻機設備。客戶在泡沫雕刻機廠家咨詢和了解設備時，銷售人員往往會問客戶選擇步進電機還是伺服電機？相對而言步進電機會便宜不少。
With the recognition of efficient and high-performance machining efficiency of CNC foam engraving machine, more and more customers are buying and importing CNC foam engraving equipment. When customers are consulting and understanding equipment in foam engraving machine manufacturers, salespeople often ask customers whether to choose stepper motor or servo motor? Relatively speaking, the price of stepping motor will be much cheaper.
那么，客戶應該如何配用步進電機驅動器呢？根據電機的電流，配用大于或等于此電流的驅動器。如果需要低振動或高精度時，可配用細分型驅動器。對于大轉矩電機，保麗龍雕刻機一臺，盡可能用高電壓型驅動器，以獲得良好的高速性能。
So, how should customers use stepper motor driver? According to the current of the motor, it is equipped with a driver greater than or equal to the current. If low vibration or high precision is needed, subdivision driver can be used. For high torque motor, how much is a styrofoam engraving machine? High voltage driver should be used as much as possible to obtain good high-speed performance.
其次，泡沫雕刻機步進電機也分為兩相和三相的。兩相電機成本低，但在低速時的震動較大，高速時的力矩下降快。三相電機則振動較小，高速性能好，比兩相電機的速度高30~50%，可在部分場合取代伺服電機。
Secondly, the stepping motor of foam carving machine is also divided into two phases and three phases. The cost of two-phase motor is low, but the vibration is large at low speed, and the torque drops quickly at high speed. The three-phase motor has less vibration and good high-speed performance, which is 30 ~ 50% higher than the two-phase motor. It can replace the servo motor in some occasions.
客戶可以根據自身加工所需，選擇相應的泡沫雕刻機驅動器電機，達到更合理的配置。
Customers can choose the corresponding foam engraving machine drive motor according to their own processing needs, so as to achieve a more reasonable configuration.
